TOURANTRAFFIC
Glass beads, conforms to GB/T24722-2009
Glass beads, conforms to GB/T24722-2009 2
Glass beads, conforms to GB/T24722-2009 3
Glass beads, conforms to GB/T24722-2009 4

Glass beads, conforms to GB/T24722-2009

Brief Introduction

The beads shall be dry, free of lumps, clusters, transparent, clean, colorless glass, smooth and spherically shaped, free from milkiness, pits, or excessive air bubbles and conform to the following specific requirements.

Product Details

 

General information:

The beads shall be dry, free of lumps, clusters, transparent, clean, colorless glass, smooth and spherically shaped, free from milkiness, pits, or excessive air bubbles and conform to the following specific requirements.

-- Defective rate - less than 20% of total quality.

-- Roundness - The glass beads(particles 0.6-0.8mm) shall have a minimum of 70 percent true spheres.

-- Refractive index - The glass beads shall have a minimum refractive index of 1.50.

-- Density - ≥ 2.4g/cm3 min.

-- Magnetic particle content - ≤0.1%

 

General gradation of Glass Beads

NO. 1 - shall be known as drop-on application for thermoplastic, two-component and water-based paint.

NO. 2 - shall be known as premixed application for thermoplastic, two-component and water-based paint.

NO. 3 - shall be known as drop-on application for cold-solvent paint.

 

Specific Properties.

The beads shall meet the gradation requirements for types as given in Table 1.

 

Table 1: Gradation of Glass Beads

Packing and storage

25kg plastic woven bag with PE inner

 

Additional Information:

Please contact with us if you require:

• Pricing and availability

• Or more specific information on this product or other products in the wide range of products manufactured by us

 

Above statements, technical information and recommendations contained herein is based on our present knowledge. It is intended to furnish general remarks on our products and their application. Therefore, the information should neither be taken literally nor as a guarantee for special characteristics of products or useful fields of application, and it implies no liability or other legal responsibility on our part,. We reserve the right to make any changes according to technological progress. If you have any questions or doubts please don’t hesitate to contact with us.

Swipe to see full table

Type

Sieve designation

Mass percent passing

-

Standard. mm

Alternate No.

-

No. 1

S>0.850

20

0

0.600<S ≤0.850

20-30

15-30

0.300<S ≤0.600

30-50

30-75

0.106<S ≤0.300

50-140

10-40

S ≤0.106

140

0-5

NO.2

S>0.600

30

0

0.300<S ≤0.600

30-50

50-90

0.150<S ≤0.300

50-100

5-50

S ≤0.150

100

0-5

NO. 3

S>0.212

70

0

S ≤0.090

170

0-4

Share:

Online Inquiry